ARCHITETTURA SONORA CUBE400 Manual de serviço - Página 6
Procurar online ou descarregar pdf Manual de serviço para Altifalantes ARCHITETTURA SONORA CUBE400. ARCHITETTURA SONORA CUBE400 6 páginas.
Imprimir página
3.7 > Upgrade a Cube with the "Light Mood" base.
1 >
1 > 2
Follow steps
2 >
The "Lighting Mood" base comes already cabled for the electical part, with net protecting the cable
locked with heat-shrinking sheaths, ready to be installed. When installing the base make sure the electrical
cable ts into the proper grove on the body, as shown in the drawing below.
bipolar cable
grove for cable
on body
6 >
Refer to the following scheme for nal installation:
Music source
STAND-BY
POWER
AS - MULTI-CHANNEL POWER AMPLIFIER
ampli er
of "1.0 Disassembly Procedure" to remove the "standard base" of your Cube.
electrical cable
3 >
Insert the cable in the through column of the base and at the same time
place the base on the Cube taking extreme care not to scratch the frame
below. IMPORTANT: the cable was previously laid into the appropriate groove
present on the Cube's body and sealed with silicone.
Place the 4 M10 screws (H), the "Grower" (L), the at stainless steel and the red
ber washers in the holes of the base with the red one in contact with the base
then the at steel one, then "grower" and nally the screw.
Using the Allen key #7 (B) turn the four M5 screws counter-clockwise until you
hear a click that indicates the correct insertion of the rst thread of the screw in
the threaded seat. Then tighten the screws by turning clockwise crosswise
(always tighten the screw opposite to the previous one) until you start feeling
resistance.
4 >
Tighten the four screws M10
(always crosswise) with the torque
wrench #7(E) set at 12 N.m.
Then
insert
the
sheath, about 40 mm long, along the
cable where it comes out from the base
and heat it with the hot air gun (G) at a
temperature about 280°C.
WARNING: do not exceed the recom-
mended
temperature
prevent the fusion of the cable.
STATUS
bipolar
audio cable
Strip LED
thermo-shrinking
in
order
to
screw (H)
5 >
Turn the Cube upside-down
back on its base, following the
Instruction Manual directions.
Voltage 90-260 VAC
external
power supply
electric cable
Last update: September 2019
Speci cation could be changed without notice
electrical cable
Grower
washer (I)
Flat steel
washer (L)
Red ber
M10
washer (M)