Cres Cor AquaTemp Manual de instalação, operação e manutenção - Página 7
Procurar online ou descarregar pdf Manual de instalação, operação e manutenção para Forno de convecção Cres Cor AquaTemp. Cres Cor AquaTemp 15 páginas. Humidity convection ovens
Imprimir página5925 Heisley Road • Mentor, OH 44060-1833
HOW TO USE THE AQUATEMP HUMIDTY
CONTROL:
*The units of the humidity control are approximate %
relative humidity . The amount of moisture will vary for
the same %RH value at different oven temperatures .
* The LOW WATER Light comes on when water pan
needs to be refilled.
*Press the ON/OFF button to turn it on .
Setting the Humidity:
1 . At any time, press the knob and the setpoint %RH will
flash.
2 . Turn the knob to the value you desire .
3 . Press the knob to set the value .
For use with the Roast-N-Hold Control:
1 . On the Retherm control, when selecting the COOK
temperature, the humidity setpoint will be flashing on
the Aquatemp control .
2 . Turn the knob on the humidity control to the desired
"Cook Humidity" value .
3 . On the Roast-N-Hold control, when selecting the
HOLD temperature setpoint, the humidity setpoint
will be flashing on the Aquatemp control.
4 . Turn the knob on the humidity control to the desired
"Hold Humidity" value .
NOTE: These humidity values then are set and switch
automatically based upon which Roast-N-Hold
mode it is in .
The DISPLAY BUTTON momentarily shows the
approximate relative humidity in the oven . When water
level is low, %RH is not correct, so no value is displayed
and the water heater does not heat .
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING INSTRUCTIONS, continued
Convection
Humidity Oven
Rev. 4 (6/15)
How to use the Automatic Water Fill:
There is a water fill connection under the bottom left rear
of the oven . Remove the plug on the end of the connector .
1 . Connect the plastic tubing provided to the connector
and the other end to your water supply . Turn water
supply on .
2 . Press and hold both the DISPLAY button and the knob
of the AquaTemp humidity control for five seconds.
3 . Turn the knob until when the display shows FILL,
select "Y" for yes and press the knob to set .
4 . Go to END to exit the menu. Auto water fill should
start .
To shut down:
1 . Press and hold both the DISPLAY button and the knob
of the Aquatemp humidity control .
2 . Turn the knob to FILL and push to enter . Select "N"
for no; go to END to exit the menu.
3 . Turn off your water supply and clean out the water pan
after it cools (See "Maintenance Instructions" on page
8) .
NOTES: It is recommended to use treated water to
prevent failure of fill valve.
If water supply pressure is high, it is recommended to
regulate it to make sure the fill valve closes reliably.
FL-2373
Page 7 of 14