Digit-KD VISION series Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Teclado Digit-KD VISION series. Digit-KD VISION series 12 páginas. Remote keypad with lcd display

Imprimir página
7.0. TOTAL ARMING
With the control panel disarmed (OFF), proceed as follows:
Digit any one of the memorized
codes (example 1, 2 and 3). On
the display 3 asterisks will appear.
Press the button
The control panel emits one beep. On the
display the message on the right appears.
The writing "ON" and the LED "UNIT ON"
will flash quickly.
After a few seconds, the writing "delay" will
appear which indicates the countdown of
the exit time (30 seconds).
At the end of the exit time, the writing "delay"
disappears and both the writing "ON" and
the LED "UNIT ON" from flashing become
fixed. The control panel is armed in DAY
mode and is fully functional.
If while arming there are zones triggered
or unbalanced not by-passed, or control
panel has low battery, the writing "ON" on
the display and the LED "ON" will flash
slowly during the exit time.
Furthermore, the message "zone in alarm" or "battery centr." will appear.
If a few zones are by-passed, during the
exit time on the display will appear the
message "zone by-p" instead of "delay".
To verify the zones by-passed, press more
times the button "FORWARD" during the
exit time. On the display the menu (in
groups of 4) are visualized with the
complete list of all zones, plus Bat (low
battery), Tmp (Tamper) and Firendio (fire).
Next to each by-passed zones a dot will
appear that flashes quickly.
To remove the menu from the display,
press the button "FORWARD" or wait for
automatic cancellation that takes place
after approximately 40 seconds.
Digit-KD instruction manual
(DAY mode)
to confirm.
ENGLISH
OFF
OK
***
ON
OK
ON
delay
OK
ON
OK
ON
delay
zone in alarm
ON
zone by -p
OK
1
2
ON
OK
3
4
In the above example, the zones 3
and 4 are by-passed.
The flashing dots will remain
ualized only during the exit time.
ON
OK
Pag. 7
vis-