Siemens SIMATIC ET 200AL Manual do equipamento - Página 18

Procurar online ou descarregar pdf Manual do equipamento para Equipamento industrial Siemens SIMATIC ET 200AL. Siemens SIMATIC ET 200AL 46 páginas. 10-link digital output module dq 8x24vdc/2a 8xm12
Também para Siemens SIMATIC ET 200AL: Manual (38 páginas), Manual (50 páginas), Manual (38 páginas), Manual (32 páginas), Manual (37 páginas), Manual (26 páginas), Manual do equipamento (28 páginas), Manual do equipamento (27 páginas), Manual (25 páginas)

Imprimir página

Siemens SIMATIC ET 200AL Manual do equipamento

3.3

Configuring PROFIBUS DP address and terminating resistor

Properties

Use the PROFIBUS address to specify at which address the ET 200AL distributed I/O system is

addressed on the PROFIBUS DP.

The PROFIBUS DP address is configured for the ET 200AL distributed I/O system with a rotary

coding switch on the front of the housing.

Requirements

The following requirements apply:

• Each address is only assigned once on the PROFIBUS DP.

• The configured PROFIBUS DP address must match the PROFIBUS address defined in the

configuration software.

• A change of the PROFIBUS DP address is only valid after POWER ON/POWER OFF on the

IM 157-1 DP interface module.

Required tools

You need the following tools to configure the PROFIBUS DP address:

• 14 mm socket wrench

• 2.5 mm screwdriver

IM 157-1 DP (6ES7157-1AA00-0AB0)

Equipment Manual, 08/2021, A5E32100641-AE

3.3 Configuring PROFIBUS DP address and terminating resistor

Wiring