Siemens SINUMERIK 828D Turning Manual - Página 12

Procurar online ou descarregar pdf Manual para Equipamento industrial Siemens SINUMERIK 828D Turning. Siemens SINUMERIK 828D Turning 49 páginas. Output of setpoints to analog drives - retrofit solution
Também para Siemens SINUMERIK 828D Turning: Instruções de ligação (16 páginas)

Imprimir página

1. Schematic Diagram

3 Commissioning

3.2.1

Commissioning procedure

•

Observe the Requirements.

•

Reset the SINUMERIK 828D to the factory settings using the drive wizard.

•

Load the commissioning files to achieve the following:

–

In the SINAMICS HLA, specific data of the internally used, purely fictitious

closed-loop hydraulic control are preassigned in order to avoid alarms.

–

All internal controllers of the SINAMICS HLA are deactivated.

3.2.2

Commissioning files

The commissioning files consist of an ACX or TEA file, both of which have the file

name "TTL_1024_SW_4_8".

You can use the files for linear and rotary axes. As soon as a TTL encoder that

supplies 1024 pulses per revolution is connected to both on-board interfaces, the

analog axis is immediately ready for operation.

If an SSI encoder, or sin/cos/EnDat encoder via SMC/SME, or a DRIVE-CLiQ

encoder is connected, you must adapt the encoder data in the commissioning

wizard.

Loading the commissioning files

Note

Create a NC/PLC/DP archive before you load the commissioning files.

Note

The procedure for loading the commissioning files is identical to that of a purely

electrical SINAMICS drive.

Load the commissioning files from a USB flashdrive:

•

Press the <MENU SELECT> key.

•

Open the "Setup" area.

Sollwertausgabe an analoge Antriebe

Entry ID: 109761423,

V1.0,

10/2018