Siemens SIWAREX WL230 BB-S SA Manual do equipamento - Página 27
Procurar online ou descarregar pdf Manual do equipamento para Equipamento industrial Siemens SIWAREX WL230 BB-S SA. Siemens SIWAREX WL230 BB-S SA 50 páginas. Base plate and elastomer bearing bb-s sa
Também para Siemens SIWAREX WL230 BB-S SA: Manual (36 páginas), Manual de Instruções (48 páginas), Manual de Instruções (44 páginas)
Imprimir página
NOTICE
Improper installation of the load cell in the compact mounting unit
An improper installation of the load cell in the compact mounting unit can destroy the load cell
and the compact mounting unit.
• Check that the load cell and compact mounting unit are installed correctly, for example, by
• To prevent water from penetrating, lay cables through cable glands in the form of a vertical
5.2
Installing the compact installation unit
5.2.1
General installation information
The installation conditions vary widely. The dead load of the load bearing implement can be very
low or relatively high. You might be dealing with a container, platform or a roller table. The
following installation instructions therefore only describe the general procedures.
To protect the load cells from damage during installation, always set up the load bearing
implement on dummies.
To position the compact mounting unit, lift the load bearing implement a few millimeters from
bracket to bracket. This section describes the assembly for this situation.
Note
Maintenance-friendly design
If necessary, replace the load cells as needed without removing the compact mounting units.
• When planning the layout, ensure that the load cells are easily accessible once they are
installed.
Depending on the installation conditions, the detailed procedure deviates from the following
description.
5.2.2
Overview
The following actions are required in order to install the compact mounting unit.
1. Preparing the load cell (Page 28)
2. Preparing the compact installation unit (Page 28)
3. Installing the load cell in the compact installation unit (Page 28)
4. Installing the compact installation unit (Page 30)
SB-S SA
Equipment Manual, 12/2020, A5E02390707B-03
checking the mounting dimensions and oscillation distances. See the section Checking the
installation (Page 33).
downwards loop.
5.2 Installing the compact installation unit
Installation
27