Siemens SIWAREX WL230 BB-S SA Посібник з експлуатації обладнання - Сторінка 27

Переглянути онлайн або завантажити pdf Посібник з експлуатації обладнання для Промислове обладнання Siemens SIWAREX WL230 BB-S SA. Siemens SIWAREX WL230 BB-S SA 50 сторінок. Base plate and elastomer bearing bb-s sa
Також для Siemens SIWAREX WL230 BB-S SA: Посібник (36 сторінок), Інструкція з експлуатації Посібник з експлуатації (48 сторінок), Інструкція з експлуатації Посібник з експлуатації (44 сторінок)

NOTICE

Improper installation of the load cell in the compact mounting unit

An improper installation of the load cell in the compact mounting unit can destroy the load cell

and the compact mounting unit.

• Check that the load cell and compact mounting unit are installed correctly, for example, by

• To prevent water from penetrating, lay cables through cable glands in the form of a vertical

5.2

Installing the compact installation unit

5.2.1

The installation conditions vary widely. The dead load of the load bearing implement can be very

low or relatively high. You might be dealing with a container, platform or a roller table. The

following installation instructions therefore only describe the general procedures.

To protect the load cells from damage during installation, always set up the load bearing

implement on dummies.

To position the compact mounting unit, lift the load bearing implement a few millimeters from

bracket to bracket. This section describes the assembly for this situation.

Note

Maintenance-friendly design

If necessary, replace the load cells as needed without removing the compact mounting units.

• When planning the layout, ensure that the load cells are easily accessible once they are

installed.

Depending on the installation conditions, the detailed procedure deviates from the following

description.

5.2.2

The following actions are required in order to install the compact mounting unit.

1. Preparing the load cell (Page 28)

2. Preparing the compact installation unit (Page 28)

3. Installing the load cell in the compact installation unit (Page 28)

4. Installing the compact installation unit (Page 30)

SB-S SA

Equipment Manual, 12/2020, A5E02390707B-03

checking the mounting dimensions and oscillation distances. See the section Checking the

installation (Page 33).

downwards loop.

5.2 Installing the compact installation unit

Installation