Siemens HB26D555W Manual de instruções - Página 22

Procurar online ou descarregar pdf Manual de instruções para Forno Siemens HB26D555W. Siemens HB26D555W 32 páginas.

Imprimir página

Problem

The appliance is not producing steam

properly

Error message "E011" appears in the dis-

play

An error message "E..." appears in the dis-

play

The appliance is not heating. "Demo" is

shown in the display

Replacing the cooking compartment bulb

Heat-resistant 25 W, 220/240 V bulbs, E14 bulb sockets and

the seals are available from the after-sales service. Please

specify the E number and FD number of your appliance.

Risk of burns!

Allow the cooking compartment and cooking compartment light

to cool before changing the bulb.

Switch off the fuse in the fuse box or unplug at the mains.

Turn the cover anti-clockwise to remove.

Screw out the bulb by turning it anti-clockwise and replace

with a bulb of the same type.

Slide the new seals and the clamping ring onto the glass

cover in the right order.

Screw the glass cover with the seals back on again.

Connect the appliance to the mains and reset the clock.

Never operate the appliance without the glass cover and seals.

Replacing the glass cover or seals

Any damaged glass cover or seals must be replaced. Please

provide the after-sales service with the E number and FD

number of your appliance.

After-sales service

Our after-sales service is there for you if your appliance needs

to be repaired. We will always find the right solution in order to

avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and

the production number (FD no.) so that we can provide you with

the correct advice. The rating plate bearing these numbers can

be found on the lower left-hand side when you open the

appliance door.

You can make a note of the numbers of your appliance and the

telephone number of the after-sales service in the space below

to save time should it be required.

Possible cause

Limescale has formed in the appliance

A button was pressed for too long or is

jammed

Technical fault.

A button combination was actuated

Changing the door seal

If the seal around the outside of the cooking compartment is

faulty, it must be replaced. Replacement seals for your

appliance can be obtained from the after-sales service. Please

specify the E number and FD number of your appliance.

Open the appliance door.

Pull off the old seal.

Push in the new door seal at one point and pull it in all the

way round. The joint must be at the side.

Check again that the seal is correctly fitted in the corners.

E no.

After-sales service

Please note that there will be a fee for a visit by a service

technician in the event of a malfunction, even during the

warranty period.

Please find the contact data of all countries in the enclosed

customer service list.

Notes/remedy

Start the descaling programme.

Press the

button to delete the error

message. Press all of the buttons individu-

ally and check if they are clean

Press the

button to delete the error

message. Reset the clock if required.

If the error message appears again, call

the after-sales service

Disconnect the power supply and recon-

nect after 10 seconds. Within 2 minutes,

press the

button for 4 seconds

FD no.