Siemens WM10K161GR Manual de instruções e instruções de instalação - Página 25
Procurar online ou descarregar pdf Manual de instruções e instruções de instalação para Máquina de lavar roupa Siemens WM10K161GR. Siemens WM10K161GR 38 páginas.
Imprimir página
Display
E:18
E:23
w
¼ flashes
Other displays
Faults and what to do about them.
Faults
Water is leaking out.
No water supply.
Detergent is not dis-
pensed.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
drained.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle started and
stopped several times.
The programme duration
is longer than usual.
Cause/remedial action
Detergent solution pump blocked. Clean the detergent solution pump.
■
~ Page 22
Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
■
~ Page 23
Water in the base tub, appliance leaking. Turn off the tap. Call the after-sales ser-
vice.
Childproof lock activated; deactivate it. ~ Page 18
Too much foam detected, a rinse cycle has been switched on ~ Page 19
Switch off the appliance, wait for five seconds and switch it back on again. If the
indicator appears again, call the after-sales service ~ Page 27
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
Start/Reload not selected?
■
Tap not turned on?
■
Filter blocked? Clean the filter. ~ Page 23
■
Supply hose kinked or trapped?
■
Safety function active. Programme stopped?
■
– – – 0 (Rinse hold = without final spin) selected?
■
Can be opened by emergency release only? ~ Page 24
■
Start/Reload or "Ready in" time selected?
■
Washing machine door closed?
■
w Childproof lock activated? Deactivate it. ~ Page 18
■
– – – 0 (Rinse hold = without final spin) selected?
■
Clean the detergent solution pump. ~ Page 22
■
Clean the waste pipe and/or drainage hose.
■
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
æ Anti-crease (depending on the model) selected?
■
Selected speed too low?
■
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
Not a fault – the unbalanced-load detection system is adjusting the imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – foam detection system active – adds an additional rinse cycle.
■
Faults and what to do about them.
en
25