Siemens dishwasher Manual de instruções de utilização - Página 14

Imprimir página

Siemens dishwasher Manual de instruções de utilização

aus

Washing the dishes

Aqua sensor *

* depending on model

The Aqua sensor is an optical measuring

device (light barrier) which measures the

turbidity of the rinsing water.

The Aqua sensor is used according to the

programme. If the Aqua sensor is active,

"clean" rinsing water can be transferred to

the next rinse bath and water consumption

can be reduced by 3–6 litres. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In the

automatic programmes the temperature

and running time can also be adjusted

to the degree of soiling.

Switching on the appliance

Turn on the tap fully.

Open the door.

Switch on ON/OFF switch

The display of the last selected

programme flashes. This programme

remains selected if no other programme

button

is pressed.

The expected programme duration

flashes on the digital display

Press the START button

Close the door.

The programme starts running.

Remaining running time display

When the programme is selected, the

remaining running time of the programme

is indicated on the digital display

The running time is determined during the

programme by the water temperature, the

number of utensils as well as the degree

of soiling and may vary (depending on the

selected programme).

Display window

Apart from information on the programme

sequence, the display window

indicates additional information on

e.g. glass protection system is active.

If you would no longer like to have this

additional information displayed, proceed

as follows.

To change the setting,

Timer programming

You can delay the start of the programme

in 1-hour steps up to 24 hours.

Open the door.

Switch on ON/OFF switch

Hold down programme button A

and press START button

the digital display

Release both buttons.

Press programme button A until the

factory set value

the digital display

By pressing the C button, you can

switch the onboard computer

(additional programme information)

off

or on

Press START button

The set value is saved.

Close the door.

Open the door.

Switch on ON/OFF switch

Press

+ button until the timer

programming display

Press

+ or – button until the

displayed time corresponds with your

requirements.

Press START button

programming is activated.

To delete timer programming, press

the

+ or – button until

is indicated on the digital display

You can change your programme

selection at any time until the

programme starts.

Close the door.

also

until on

is indicated.

is indicated on

jumps to

, timer