Siemens dishwasher Manual de instruções de utilização - Página 15

Imprimir página

Siemens dishwasher Manual de instruções de utilização

End of programme

The programme has ended when the

value

is indicated on the numerical

display

The end of the programme is also

indicated by an acoustic signal.

This function can be changed as follows:

Open the door.

Switch on ON/OFF switch

Hold down programme button A

and press START button

the digital display

Release both buttons.

Press programme button A until the

factory set value

the digital display .

To change the setting,

press programme button C .

Each time the button is pressed, the set

value increases by one level; when the

value of

has been reached, the

display jumps back to

Press START button

is saved.

Close the door.

Automatic switch off when

programme ends

To save energy, the dishwasher is switched

off 20 minutes after the programme ends.

This function can be changed as follows:

Open door.

Switch on ON/OFF switch

Hold down programme button A and

press START button

is indicated on the digital display.

Release both buttons.

Press programme button A until the

factory set value

the digital display

To change the setting:

Press the button C to switch

the function off

Press START button

The set value is saved.

Close door.

until on

is indicated.

is indicated on

(off).

, the set value

until

is indicated on

or on

Switching off the appliance

Short time after the end of the programme:

Open the door.

Switch off ON/OFF switch

Turn off the tap (not applicable

if Aqua-Stop fitted).

Remove the utensils when they have

cooled down.

Warning

At the end of the programme please open

the door fully and not partially when

emptying the dishwasher. Any escaping

water vapour could damage sensitive

worktops.

Interrupting the programme

Open the door.

Switch off ON/OFF switch

The LEDs go out. The programme

is saved.

If the door was opened on an appliance

which has a warm water connection

or is heated, first leave the door ajar

for several minutes and then close.

Otherwise, expansion (pressure) may

cause the appliance door to spring

open or water to run out of the

appliance.

To continue the programme, switch

on the ON/OFF switch

Close the door.

Terminating the programme

(Reset)

Open the door.

Press START button

approx 3 sec.

on the digital display

Close the door.

The programme sequence lasts

approx. 1 min.

is indicated on the digital

display

(buzzer sounds).

Open the door.

Switch off ON/OFF switch

Close the door.

aus

again.

for

is indicated