Siemens dishwasher Manual de instruções de utilização - Página 18

Imprimir página

Siemens dishwasher Manual de instruções de utilização

Washing dishes

Reduce costs!

If only a small number of

dishes have been loaded into

the dishwasher, selecting a

programme that operates at

the next lowest temperature

will usually suffice.

Programme data

The stated programme data are based on

standard operating conditions. The values

can vary considerably according to:

different amounts of dishes

temperature of mains water supply

pressure of mains water supply

ambient temperature

fluctuations in mains voltage

machine-related factors (e.g.

temperature, water volume, ...).

Energy and water consumption is reduced

by up to 1/4 when dishes are washed in

the upper basket only.

Water consumption values are based on a

water hardness setting of 4.

Aqua sensor *

* on applicable models

The Aqua sensor is an optical measuring

device which measures the turbidity of the

rinsing water. A light barrier can detect

dissolved food remnants in the water, e.g.

egg, fat and oats.

The Aqua sensor is used according to

the programme. When the Aqua sensor

is active, "clean" rinsing water may be

transferred into the next rinsing bath

and/or the temperature adjusted. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In this

way the water consumption is reduced by

approx. 4 litres for utensils which are "less"

dirty.

Switching the dishwasher ON

Turn on the tap.

Set main switch

Indicators light up according to the last

programme that was selected.

This same programme will run again if

no other programme button

pressed

The numerical display

expected duration of the programme.

Close door.

The programme starts automatically.

Optical indicator during

operation *

* With some models

During the rinse programme a light point

appears on the floor below the device's

door. Only open the dishwasher door

when the light point has disappeared.

In the case of built-in dishwashers with

flush front the light point will not be visible.

End of programme

The end of the programme is indicated by

a buzzer. This function can be changed as

follows:–

Hold down Function button C

pressed and switch on main switch

, then let the buttons go.

Function Button C flashes, and the

digital display indicates the value

which was set at the factory

(semi-loud).

To change the setting:

Press Function button C .

Each depression of the button

increases the set value by one,

when

is reached, the display

jumps back to

Switch off the main switch

The set value is stored in the appliance.

to ON.

shows the

(off).