Cisco SGE2000 Manual de configuração - Página 35

Procurar online ou descarregar pdf Manual de configuração para Router de rede Cisco SGE2000. Cisco SGE2000 46 páginas. Nx-os fabric extender
Também para Cisco SGE2000: Manual de instalação rápida (32 páginas), Nota de lançamento (16 páginas), Ficha de dados (5 páginas), Manual de atualização de firmware (5 páginas), Manual de início rápido (2 páginas)

Configuring the Fabric Extender

Dual-homing of a Server to a FEX with FabricPath

To configure FabricPath interfaces for two Cisco Nexus 7000 switches that are connected with FabricPath,

perform the following tasks on each switch:

• Enable FabricPath on each switch.

• Configure the interfaces that you want to designate as FabricPath interfaces.

• Set the STP priority device to 8192 on all FabricPath Layer 2 gateway devices.

• (Optional) Set the STP domain ID for each of the separate STP domains that are connected to the

FabricPath network.

• (Optional) Configure a FEX switch ID.

To configure FabricPath interfaces, follow these steps:

1 (Optional) Enable FabricPath on each switch.

switch# config terminal

switch(config)# feature fabricpath

switch(config-lldp)# exit

switch(config)#

2 After you enable FabricPath on the switch, configure the specified interface as FabricPath interfaces.

switch(config)# interface ethernet 1/2

switch(config-if)# switchport mode fabricpath

switch(config-if)# exit

switch(config)#

3 Configure the STP priority for all Rapid PVST+ VLANs as 8192.

switch# config terminal

switch(config)# spanning-tree vlan 11-20 priority 8192

switch(config)#

4 Configure the STP priority for all MST instances as 8192.

switch# config terminal

switch(config)# spanning-tree mst 1-5 priority 8192

switch(config)#

5 (Optional) Configure the STP domain ID on each FabricPath Layer 2 gateway switch attached to the

FabricPath network.

switch# config terminal

switch(config)# spanning-tree domain 5

switch(config)

6 (Optional) Configure the FEX switch ID.

See the Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide for information on configuring

Note

FEX.

Note

FEX VPC+ configurations are only supported on F2 modules.

If you are setting up an initial FEX VPC+ configuration on an F Series module, follow these steps:

a In the VPC domain configuration mode, enable partial DF mode with the fabricpath multicast

OL-25816-02

load-balance command.

Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide

Configuration Examples