Actuonix LAC Manual de configuração do utilizador - Página 3
Procurar online ou descarregar pdf Manual de configuração do utilizador para Controlador Actuonix LAC. Actuonix LAC 9 páginas. Usb control and configuration of the linear actuator control board
Imprimir páginaApply power to the LAC board. If using the RC connector, do not connect a separate
power supply. This can result in large currents flowing between power supplies. If you
do wish to connect a separate supply, ensure the Red RC wire is disconnected.
+/- Power terminals
RC connector : No other power
You system should now operate normally with Actuonix's default configuration.
Actuonix LAC : Battery Powered, L12-P Actuator, Potentiometer Controlled
To manually adjust the LAC configuration, rotate the four potentiometers on the LAC to
the desired locations. Counter clockwise reduces the corresponding value, while
clockwise rotation increases the value. Power must be cycled before changes take effect.
Limits –
The Potentiometer closer to the USB connector is the retract limit, and the one
further away is the extend limit. For maximum stroke, set each potentiometer to fully
clockwise. Rotating counter clockwise from this position will move the limits inward,
from either end. If your settings overlap, the actuator will not move at all.