Cisco WS-X45-SUP6-E - Supervisor Engine 6-E Nota de instalação e configuração - Página 10
Procurar online ou descarregar pdf Nota de instalação e configuração para Router de rede Cisco WS-X45-SUP6-E - Supervisor Engine 6-E. Cisco WS-X45-SUP6-E - Supervisor Engine 6-E 30 páginas.
Imprimir página
Supervisor Engine 6-E
Table 1
LED
Link
Active
10-Gigabit Ethernet Uplink Ports
The 10-Gigabit Ethernet uplink ports operate in full-duplex mode only. These ports use the
hot-swappable X2 optical transceivers. The X2s have SC connectors to interface with multimode fiber
(MMF) and single-mode fiber (SMF) cable. For further information on X2s, see the
Guidelines and Installation" section on page
When two Supervisor Engine 6-Es are present in a Catalyst 4507R, Catalyst 4507R-E, Catalyst 4510R
or Catalyst 4510R-E switch, one X2 uplink is active on both the primary (active) and secondary
(standby) supervisor engines by default, or two uplinks will be active in a nonredundant configuration.
Gigabit Ethernet SFP Uplink Ports
If you want to use SFPs instead of X2s as your uplink transceivers, you can use Cisco TwinGig converter
modules in the X2 slots. Installation documentation for Cisco TwinGig converter modules can be found
at:
http://www.cisco.com/en/US/docs/switches/lan/catalyst3750e_3560e/hardware/install/notes/1757202.html
Ethernet Management Port
The Ethernet management port can be used (in ROMMON mode only) to recover a switch software
image that has been corrupted or destroyed due to a network catastrophe. When using Cisco IOS Release
12.2(50)SG or later, this port can also perform the same functions as the console port. For earlier Cisco
IOS software releases, this port is not active while the switch is operating normally.
Console Port
The Catalyst 4500 E-series Supervisor Engine 6-E console port has an EIA/TIA-232 RJ-45 connector.
The console port allows you to perform the following functions:
•
•
•
Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E
10
Supervisor Engine LEDs (WS-X45-Sup6-E) (Continued)
LED Status
Green
Orange
Flashing orange The power-on self-test indicates a faulty port.
Off
Green
Off
Configure the switch from the CLI
Monitor network statistics and errors
Configure SNMP agent parameters
Description
Indicates the status of the 10/100BASE-T Ethernet management
port or uplink ports.
The link is operational.
The link is disabled by user.
No signal is detected or there is a link configuration failure.
Indicates whether the uplink port is active.
The port is active.
The port is not active.
19.
"X2 Handling
78-18337-01