Cisco WAP121 Manual de início rápido - Página 5

Procurar online ou descarregar pdf Manual de início rápido para Ponto de acesso sem fios Cisco WAP121. Cisco WAP121 13 páginas. Reboot and reset to factory default settings
Também para Cisco WAP121: Revisão (6 páginas), Ficha de dados (7 páginas), Manual de início rápido (13 páginas), Brochura e especificações (4 páginas), Manual (4 páginas), Manual (4 páginas)

Imprimir página
Cisco WAP121 Manual de início rápido
To mount the WAP device to a wall or ceiling:
Determine where you want to mount the device. Verify that the
S
1
TEP
surface is smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface 1.85 inches (47 mm) apart for
S
2
TEP
the Cisco WAP121. For the WAP321, drill the holes 2.75 inches
(70 mm) apart.
Insert a screw into each hole, leaving a gap between the surface
S
3
TEP
and the base of the screw head.
Place the upper slots of the bracket over the screws, adjust the
S
4
TEP
screws accordingly, and slide the bracket down until the screws fit
snugly into the slots.
Using the bracket as a template, drill two more holes for the lower
S
5
TEP
screws.
Insert a screw into each lower hole.
S
6
TEP
Slide the WAP device into the bracket, placing the cables or cords
S
7
TEP
through the break-out tab found in the back of the bracket.
Connecting the Cisco WAP121 and
4
WAP321 Wireless-N Access Points
The default configuration of the device has the Wi-Fi radio turned off. You
must perform the initial configuration using a wired Ethernet connection. To
connect the device to the wired network:
Connect the Ethernet cable to the Ethernet port of a switch or a
S
1
TEP
router.
Connect the other end of the network Ethernet cable to the
S
2
TEP
Ethernet port of the wireless access point.
If PoE is not provided, for the Cisco WAP121 plug in the power
S
3
TEP
adaptor to provide power to the device. For the Cisco WAP321, the
power adaptor is sold separately.
After installation, all lights should be active. Refer to
Hardware Installation, page 6
switch.
Cisco WAP121 and WAP321 Wireless-N Access Points
for details about the different lights on each
Verifying the
5