Epson L4150 Series Começar aqui - Página 2

Procurar online ou descarregar pdf Começar aqui para Impressora tudo em um Epson L4150 Series. Epson L4150 Series 4 páginas.
Também para Epson L4150 Series: Começar aqui (2 páginas)

Imprimir página

When the ink tank is full, remove the ink bottle and

securely close the ink tank cap. Place the remaining ink

aside; you will need it later.

Note:

Replace the bottle cap and tighten it.

Repeat the previous steps for the other colors.

Close the ink tank cover and then the scanner unit.

Connect the power cord to the back of the product and to

an electrical outlet.

Caution:

Do not connect to your computer yet.

Press the

power button to turn on the product.

Note:

If all lights are flashing, turn off the product and check that

no protective material has been left inside the product.

Press and hold the

stop button for 3 seconds until the

power light starts to blink and ink charging begins. Ink

charging takes about 10 minutes. When the

stops blinking, ink charging is complete.

Caution:

Do not turn off the product, raise the scanner unit,

or load paper while the product is charging or you'll waste ink.

Note:

After some ink is used for charging, the rest is available for

printing.

See the online User's Guide for information about loading

capacity and available paper types and sizes.

power light

To complete filling the ink tanks, repeat steps 1 through 6

using the remaining ink in the bottles.

Note:

Replace the bottle cap before disposing of the bottles.

Close the ink tank cover and scanner unit.

Load paper

Make sure the product is not charging. Then flip the

feeder guard forward, raise the paper support, and tilt it

backwards slightly.

Slide the edge guides all the way out.

Load paper, glossy or printable side up and short edge

first, in the middle of the rear paper feed slot.

Slide the edge guides against the paper, but not

too tightly.

Pull out the output tray.