Cisco 3020 - Cisco Catalyst Blade Switch Manual de iniciação - Página 9

Procurar online ou descarregar pdf Manual de iniciação para Hardware de rede Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 37 páginas. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Também para Cisco 3020 - Cisco Catalyst Blade Switch: Manual de iniciação (31 páginas), Especificação rápida (12 páginas), Nota de lançamento (41 páginas), Nota de lançamento (27 páginas), Nota de lançamento (23 páginas), Nota de lançamento (21 páginas), Manual de instalação (21 páginas)

Imprimir página

Cisco 3020 - Cisco Catalyst Blade Switch Manual de iniciação

Step 6

Push the release latch on the front of the switch module to the closed position.

Switch Module IP Addresses

IP addresses can be assigned to two of the switch module interfaces:

• The fa0 Ethernet interface. This Layer 3 Ethernet interface is connected to the Onboard

Administrator through which you can manage the switch module. It is used only for switch

module management traffic, not for data traffic.

• The VLAN 1 interface. You can manage the switch module from any of its external ports through

VLAN 1.

If you want to assign the VLAN 1 IP address through Express Setup, you must start that process

immediately after installing the switch module in the blade server. If you miss the opportunity to have

the IP address assigned in this way, you can remove and then re-install the switch module. See the

"Running Express Setup" section on page 9 for instructions.

When you install the switch module, you need to determine whether the Onboard Administrator is

connected to a network in which a DHCP server is also connected or if the Onboard Administrator

has been configured as a DHCP server. If either of these conditions is true, the switch module

automatically obtains an IP address for its fa0 Ethernet interface that is connected to the Onboard

Administrator. In this case, a VLAN 1 IP address is not assigned, and to set up the switch module by

using the Device Manager you must use the fa0 interface IP address that the DHCP server assigns.

See the "Using the Onboard Administrator to Assign an IP Address to the Switch Module fa0

Interface" section on page 14 for how to set up the switch module if the IP address is being assigned

dynamically.

Running Express Setup

You need to supply this equipment to run Express Setup:

• PC

• Ethernet (Category 5) straight-through cable (as shown)