Cisco 3110 Manual - Página 14

Procurar online ou descarregar pdf Manual para Hardware de rede Cisco 3110. Cisco 3110 42 páginas.
Também para Cisco 3110: Começar a trabalhar (42 páginas)

Cisco 3110 Manual
Rear Panel
Figure 7: Secure Firewall 3100 Rear Panel
1
Power on/off switch
Power supply module 1
3
5
Power supply module 1 OK LED
7
Dual Fan Module 1 LED
9
Dual Fan Module 2 LED
11
Power supply module 2
13
Power supply module 2 OK LED
15
Two-post grounding pad
Note
Power Switch
The power switch is located to the left of power supply module 1 on the rear of the chassis. It is a toggle
switch that controls power to the system. If the power switch is off but the power cord is plugged in and
the power supply is flashing green, the system is in standby position, and only the 3.3-V standby power
is enabled from the power supply module. The 12-V main power is OFF. When the switch is in the ON
position, the 12-V main power is turned on and the system boots.
Before you move the power switch to the OFF position, use the shutdown commands so that the system
can perform a graceful shutdown. This may take several minutes to complete. After the graceful shutdown
is complete, the console displays It is safe to power off now. Wait until the front panel
PWR LED flashes momentarily and is off before removing AC power.
See
for more information on using the shutdown commands.
Overview
14
The two-post grounding lug and two
screws are included in the accessory
kit.
Front Panel LEDs, on page 11
2
Power LED below
Note
Power supply module 1 FAIL LED
4
6
Power supply module 1 connector
8
Dual fan module 1
10
Dual fan module 2
12
Power supply module 2 FAIL LED
14
Power supply module 2 connector
for the PWR LED description. See the
Overview
This power LED has the same
behavior as the front panel LED.
See
Front Panel LEDs, on page 11
for more information.
FXOS Configuration Guide