- ページ 14

ネットワーク・ハードウェア Cisco 3110のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3110 42 ページ。
Cisco 3110 にも：はじめに (42 ページ)

Rear Panel

Figure 7: Secure Firewall 3100 Rear Panel

Power on/off switch

Power supply module 1

Power supply module 1 OK LED

Dual Fan Module 1 LED

Dual Fan Module 2 LED

Power supply module 2

Power supply module 2 OK LED

Two-post grounding pad

Note

Power Switch

The power switch is located to the left of power supply module 1 on the rear of the chassis. It is a toggle

switch that controls power to the system. If the power switch is off but the power cord is plugged in and

the power supply is flashing green, the system is in standby position, and only the 3.3-V standby power

is enabled from the power supply module. The 12-V main power is OFF. When the switch is in the ON

position, the 12-V main power is turned on and the system boots.

Before you move the power switch to the OFF position, use the shutdown commands so that the system

can perform a graceful shutdown. This may take several minutes to complete. After the graceful shutdown

is complete, the console displays It is safe to power off now. Wait until the front panel

PWR LED flashes momentarily and is off before removing AC power.

See

for more information on using the shutdown commands.

Overview

The two-post grounding lug and two

screws are included in the accessory

kit.

Front Panel LEDs, on page 11

Power LED below

Note

Power supply module 1 FAIL LED

Power supply module 1 connector

Dual fan module 1

Dual fan module 2

Power supply module 2 FAIL LED

Power supply module 2 connector

—

for the PWR LED description. See the

Overview

This power LED has the same

behavior as the front panel LED.

See

Front Panel LEDs, on page 11

for more information.

FXOS Configuration Guide