Sony Z90 Manual do produtor de Cctv - Página 6

Procurar online ou descarregar pdf Manual do produtor de Cctv para Câmara de vídeo Sony Z90. Sony Z90 17 páginas. Full auto settings

SETTING UP THE CAMERA AUDIO

When you set up your camera you will also need to set up the Audio. As a default setting, if the

microphone is not attached NO AUDIO will record.

ATTACHING THE MICROPHONE

Open the Mic latch & place the microphone into the holder. Make sure

the rubber holder is positioned in the camera latch correctly.

Clip the latch shut & plug the XLR cable into "INPUT 1".

Make sure the XLR cable is fully connected, you should hear it click into

place.

To remove the cable, hold down the metal tab and pull the cable out.

SINGLE MICROPHONE SETTINGS

When using only the shotgun microphone with

automatic settings the audio panel should be set to

these settings.

CONTORL OPTIONS

ATT (Attinuation) - Will lower the max recording

volume by 10db or 20db.

INPUT - LINE: mix from sound board, MIC: powered

mic, MIC +48v: Phantom power for microphone

LOW CUT - cuts out the lowest frequency sounds (cuts wind noise & electric hum)

CH VOLUME - AUTO/MANUAL switch & volume level wheel

DOUBLE MICROPHONE SETTINGS

To have multiple audio sources plugged into the camera

you need to change the REC CH SELECT to CH1.

This will split the controls and record INPUT 1 and

INPUT 2 onto separate channels that you will mix

later.

You will hear the audio from INPUT 1 in your LEFT ear

INPUT 1

INPUT 2

and the audio from INPUT 2 in your right ear.

CONTROLS

At this point you can adjust the input settings individually.

! 6