Argo CLOVER Manual de Instruções - Página 7
Procurar online ou descarregar pdf Manual de Instruções para Aquecedor Argo CLOVER. Argo CLOVER 12 páginas. Wall-mounted ceramic fan heater
AUTOMATIC FLAP SWIVEL
Press the
button on the control panel or
ACTIVATION OF SUMMER VENTILATION (FAN) AND HEATING (ECO – COMFORT) MODES
Press the
button on the control panel or
In stand-by mode the LED display is the following:
In Summer ventilation (FAN) mode the LED display is the following:
In ECO heating mode (1100 W) the LED display is the following:
In COMFORT heating mode (2000 W) the LED display is the following:
To return to stand-by mode press the buttons
The default set temperature is 23 °C. The fan heater switches off about 30 seconds after the stand-by mode has been
activated.
ECO SMART FUNCTION
The fan heater operates at maximum power (COMFORT mode) when the set temperature is at least 4 °C higher than
the room temperature; if the set temperature is 0-2 °C higher than the room temperature, the fan heater operates at
medium power (ECO mode), if the room temperature is higher than the set temperature the fan heater switches off and
starts operating again when the room temperature drops 2 °C below the set temperature.
TEMPERATURE REGULATION
The temperature can only be set via the remote control. Press the + or – buttons to regulate the desired temperature
(from 10 °C to 49 °C).
If you set the temperature to 25 °C the "°C" LED comes on as shown in the figure:
Press
to cancel the temperature setting.
ON/OFF DAILY TIMER SETTING
In stand-by mode, press the
pressing on the same button to move on in intervals of 1 h: the default set temperature when it switches on is 23 °C.
When the appliance is operating, to set the switch-off timer press the
V 07/22
on the remote control to select the operating mode..
on the remote control to select the operating mode.
or
again respectively on the appliance and on the remote control.
button to set the switch-on timer. The switch-on timer can be set from 1 to 12 hours, by
°C
, button; the switch-off button can be set from
20