Argo HI FLOOR RAY Manual de Instruções - Página 7

Procurar online ou descarregar pdf Manual de Instruções para Aquecedor Argo HI FLOOR RAY. Argo HI FLOOR RAY 9 páginas. Micathermic panel heater

Wall-mounting: how to assemble the panel brackets and mount it to the wall

The panel packaging contains all the accessories necessary for wall-mounting.

To wall-mount, proceed as follows:

1. Mark out on the wall the points to be drilled for Fischer rawlplug insertion. The holes must be 332 mm apart, as

shown in the figure.

2. Drill the holes in the wall

rawlplugs must be placed

Screw

the

3. Fit the wall-mounting brackets to the back of the panel using the screws supplied.

4. Mount the panel by inserting the screws fixed to the wall into the rear brackets. Lower the panel to allow it to fit

perfectly into a straight, stable position. The lower bracket serves as further support only.

It is important that the panel is assembled straight.

Choose a suitable place to position the panel heater, considering the general safety warnings given in the first part of this

manual. Only use this panel in an upright position.

Insert the plug into the electrical socket, ensuring that voltage is compliant with that specified on the panel data plate

V 09/16

332 mm

Min. 500 mm

screws

APPLICATION USING THE REAR

SUPPORTS, SEEN FROM ABOVE

HOW TO USE THE PANEL HEATER

and insert the Fischer rawlplugs. The Fischer

at a height of at least 500 mm from the ground.

supplied into the rawlplugs.

INSTALLATION COMPLETE