Cisco 6160 Manual de procedimentos de instalação - Página 15

Procurar online ou descarregar pdf Manual de procedimentos de instalação para Hardware de rede Cisco 6160. Cisco 6160 32 páginas. Without a pots splitter configuration
Também para Cisco 6160: Manual de referência rápida (38 páginas), Manual de instalação do hardware (21 páginas), Notas de instalação e substituição (18 páginas)

Imprimir página

Cisco 6160 Manual de procedimentos de instalação

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

4.2.7 Connect the BITS Clock Contacts

This step is optional.

Note

Complete the following steps to connect the BITS clock to the wire-wrap pins on the I/O card:

Caution

Use extreme caution when wire-wrapping the pin connections for the STAT_ALARMS and

BITS_A/BITS_B pins. Incorrect wire connections will cause damage to the equipment.

Step 1

Measure wire long enough to connect the appropriate pin on the I/O card to the BITS clock. See

Table 2-4

Note

Use a wire stripper to remove the casing from both ends of the wire.

Step 2

Step 3

Use a wire-wrapping tool to attach the wire to the appropriate pins for the slot in which the primary NI-2

card is installed.

Note

Use a wire-wrapping tool to attach the other end of the wire used in

Step 4

Repeat

Step 5

Repeat

Step 6

4.2.8 Connect the Cisco 6160 to the MDF

Use the cables described in

backplane to the MDF. This connection is for xDSL data flow between the Cisco 6160 system and

the MDF.

For additional information about the Cisco 6160 backplane connectors, see the

Note

page

OL-2190-02 B0

for wire specifications.

See the

"I/O Cards" section on page 1-43

I/O card. See

Appendix C, "Connector and Pinout Specifications,"

The BITS pins on I/O cards are slot specific. BITS_A pins are assigned to slot 11 and BITS_B

pins are assigned to slot 10. Each BITS clock input is independent and terminated at 100 ohms.

Step 1

through

Step 4

to wire wrap the appropriate pins for a secondary (redundant) NI-2 card.

Step 1

through

Step 5

for each Cisco 6160 chassis being installed.

Table 2-4

1-11.

for an illustration of the pinouts that are located on the

to connect the eleven Champ connectors located on the Cisco 6160

Cisco 6160 Hardware Installation Guide

Installation Procedures

for pinout descriptions.

Step 3

to the BITS clock.

"Backplane" section on

4-15