Sony XCL-CG510C Manual técnico - Página 9

Procurar online ou descarregar pdf Manual técnico para Câmara digital Sony XCL-CG510C. Sony XCL-CG510C 48 páginas. Digital video camera module

Connecting the cables

Connect the camera cable (c) to the DC power input

connector (a) and the Camera Link cable (d) to the

DIGITAL Interface connector (b) respectively. If you

use a camera module interface board with support for

PoCL, you can operate the camera even if you do not

connect the camera cable to the DC power input

connector. When you connect the Camera Link cable,

turn the two fastening screws (e) on the connector to

secure the cable tightly.

Connect the other end of the camera cable to the DC-

700/700CE and the other end of the Camera Link cable

to the camera module interface board.

Note

Please be careful with the points below, as they may be

the cause of camera or camera image input board failure.

– Connect or disconnect camera cables or camera link

cables while the power is not supplied.

– Supply power after confirming each cable is firmly

connected.

– Do not supply power from both camera cable and

camera link cable simultaneously.

– If you use the camera with PoCL connection, make

sure to connect a cable that supports PoCL.

Controlling the camera from the

host device

You can control the camera from host device such as a

computer.

You can send a command corresponding to the control

items, with parameters for the desired settings, if

necessary, from the host device to control the camera.

Refer to "Camera Control Commands" on page 37 for

details on how to send a command and its parameter.

Note

Make sure to supply power to the camera module and

confirm that the camera module is operating before

inputting a trigger signal. If you input trigger signal to a

camera module without the power supplied, this may

cause a malfunction of the camera module.