Cisco Firepower 4150 Manual - Página 23

Procurar online ou descarregar pdf Manual para Hardware de rede Cisco Firepower 4150. Cisco Firepower 4150 42 páginas. Rack-mount and ground the chassis
Também para Cisco Firepower 4150: Manual de manutenção e atualização (20 páginas), Manual (36 páginas), Manual (26 páginas), Manual (8 páginas), Começar a trabalhar (42 páginas)

Imprimir página

Overview

Cable and operating

distance

Power Supply Modules

The Firepower 4100 supports two AC or DC power supply modules so that dual power supply redundancy

protection is available. Facing the back of the chassis, the power supply modules are numbered left to right,

for example, PSU1 and PSU2.

Note

Attention

See

Remove and Replace the Power Supply Module

supply module.

AC Power Supply

The power supplies can supply up to 1100-W power across the input voltage range. The load is shared when

both power supply modules are plugged in and running at the same time. The power supply modules are

hot-swappable.

Table 7: AC Power Supply Module Hardware Specifications

Description

Input voltage

Maximum current

Core diameter (microns)

G.652

Do not mix AC and DC power supply modules in one chassis.

After removing power from the chassis either by moving the power switch to OFF or unplugging the power

cord, wait at least 10 seconds before turning power back ON.

Make sure that one power supply module is always active.

Modal bandwidth

(MHz/km)

Single mode

for the procedure for removing and replacing the power

Specification

100 to 240 V AC

13 A (at 100 V AC)

The system power requirements are lower than the power

Note

supply module capabilities. See

page 29

for the system power requirements.

Power Supply Modules

Cable distance

Half the

Note

distance

specified by

the IEEE

standard.

5 km

Hardware Specifications, on

Overview