Cisco PIX 501 Manual de início rápido - Página 12

Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede Cisco PIX 501. Cisco PIX 501 20 páginas. Data sheet
Também para Cisco PIX 501: Manual de início rápido (20 páginas), Ficha de dados (8 páginas), Manual de início rápido (21 páginas), Manual de início rápido (18 páginas)

Follow these steps to use an activation key:

Ensure that the image in Flash memory and the Running Image are the same.

Step 1

From the CLI, enter the activation-key activation-key-four-tuple command, replacing

Step 2

activation-key-four-tuple with the activation key obtained from Cisco.

Note

Make sure that you are in config mode to enter a new activation key.

Reboot the PIX Firewall by powering it off and then on again.

Step 3

After the key update is complete, the system is reloads again to update the running image.

For activation key examples or upgrade troubleshooting, refer to the Cisco PIX Firewall and VPN

Configuration Guide, available at the following website:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/index.htm

Active Host Limitation

The PIX 501 supports up to 10 active hosts on the inside network, or 50 active hosts on the inside

network if the optional 50-User License has been purchased. A host is considered active when any of

the following statements are true:

• The host has passed traffic through the PIX Firewall in the last 30 seconds

• The host has an established NAT/PAT translation through the PIX Firewall

• The host has an established TCP connection or UDP session through the PIX Firewall

• The host has an established user authentication through the PIX Firewall

Refer to the System Properties>Timeout online help within PDM for the default inactivity timeout

values associated with each of the preceding bulleted items.