Cisco Nexus 7000 Series Manual de instruções de instalação - Página 23

Procurar online ou descarregar pdf Manual de instruções de instalação para Servidor Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 39 páginas. Switch chassis
Também para Cisco Nexus 7000 Series: Manual de referência (2 páginas), Referência (34 páginas), Manual de instalação (18 páginas), Configuração (8 páginas), Manual de configuração (28 páginas), Manual de início rápido (10 páginas), Manual de início rápido (29 páginas), Manual de instruções de substituição (14 páginas), Manual de instruções de substituição (21 páginas), Manual de instalação (16 páginas), Manual de resolução de problemas (10 páginas)

Figure 14

Chassis Foot

Flat-blade screwdriver

slot for removing

chassis foot

If you have not already done so, review the safety guidelines in the section "Lifting the Chassis

Safely" on page 8. Then follow these steps to install the chassis in the rack:

Two people are required to perform this step. With a person positioned at either side of the

Step 1

chassis, grasp the bottom edge of the chassis with one hand near the front and the other near

the back. Slowly lift the chassis in unison. Avoid sudden twists or moves to prevent injury.

(See Figure 5 on page 9.)

Step 2

With the chassis positioned so that the end with the ears attached is farthest from the rack,

insert the opposite end of the chassis into the rack between the brackets, then slowly lower

the chassis until it rests on the two ledges.

Slide the chassis back into the rack along the ledges. (See Figure 15.)

Step 3

To remove a chassis foot, use a 1/4-inch ﬂat-blade screwdriver or insert an open-end

Step 4

7/16-inch wrench (or an adjustable wrench set at 7/16) between the underside of the chassis

and the foot. Turn the foot clockwise (counterclockwise if the chassis is directly above you)

until the foot drops out of the chassis.

When the chassis feet are removed, continue sliding the chassis into the rack until the ears

Step 5

meet the front mounting posts on both sides of the rack.

Secure each ear to the rack-mounting post with two 10-32 x 5/8-inch, Phillips pan-head

Step 6

screws.

This completes the procedure for moving the chassis into the rack.

If your installation requires that the chassis be electrically isolated from the rack, proceed to the next

section. Otherwise, proceed to the section "Replacing Power Supplies and Interface Cables" on

page 25.

Underside of chassis

Chassis foot

removal 7/16" nut

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions

Chassis foot

Installation