Cisco Nexus 7000 Series Manual de instruções de substituição - Página 14

Procurar online ou descarregar pdf Manual de instruções de substituição para Servidor Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 14 páginas. Switch chassis
Também para Cisco Nexus 7000 Series: Manual de referência (2 páginas), Manual de instruções de instalação (39 páginas), Referência (34 páginas), Manual de instalação (18 páginas), Configuração (8 páginas), Manual de configuração (28 páginas), Manual de início rápido (10 páginas), Manual de início rápido (29 páginas), Manual de instruções de substituição (21 páginas), Manual de instalação (16 páginas), Manual de resolução de problemas (10 páginas)

This document is to be used in conjunction with the Cisco 7000 Hardware Installation and Maintenance publication.

APPI, ciscoBus, Cisco Systems, CiscoWorks, CxBus, Netscape, The Packet, and SMARTnet trademarks, and the Cisco logo is a registered

trademark of Cisco Systems, Inc. All other products or services mentioned in this document are the trademarks, service marks, registered

trademarks, or registered service marks of their respective owners.

Checking the Installation

Perform the following steps to verify that the new blower is installed correctly.

Step 1:

Turn all power supplies back ON. The AC Power LED on all power supplies

should light. If any do not, or if the DC Fail LED is lit, the power supply has

failed. Check the power cables to ensure they are connected.

Step 2:

Listen for the blower; you should immediately hear it operating. If you do

not hear it, turn OFF the system power and do the following:

Remove the top and bottom front chassis panels (refer to "Removing and

Replacing the Front Chassis Panels" on page 6).

Check the blower power connector and ensure that it is fully seated in

the backplane port by pinching the sides and pushing it ﬁrmly into the

port.

Check the two wires between the blower and the power connector: the

red or purple +24V wire and the black ground wire. Ensure that they

have not pulled out of the power connector by pinching each wire near

the back connector and pushing it ﬁrmly into the connector.

Replace the front chassis panels, turn the power supplies back ON, and

listen for the blower.

Step 3:

If after several attempts the blower does not operate, or if you experience

trouble with the installation (for instance, if the captive blower screws do not

align with the backplane holes), contact a service representative or refer to

"Obtaining Technical Assistance" on page 2.

This completes the blower replacement.