Cisco ONS 15454 Instalar - Página 17

Procurar online ou descarregar pdf Instalar para Servidor Cisco ONS 15454. Cisco ONS 15454 32 páginas. Four-shelf and zero-shelf bay assembly
Também para Cisco ONS 15454: Manual de instruções de instalação (22 páginas), Instalar (32 páginas), Desembalagem e instalação (42 páginas), Desembalagem e instalação (40 páginas)

Imprimir página

Chapter 1 Install the Shelf and Backplane Cable

Complete the

Step 4

the EIA/TIA-232 port on the TCC2/TCC2P) are required to access TL1 using the craft interface.

Caution

Complete one of the following:

Step 5

•

Stop. You have completed this procedure.

NTP-A120 Install an External Wire-Wrap Panel to the AEP

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Position the lower cover over the AEP. Make sure that the AEP AMP Champ connectors protrude

Step 1

through the cutouts in the lower cover

78-18537-01

"DLP-A22 Install the TL1 Craft Interface" task on page 17-29

Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the

wristband cable into the ESD jack located on the lower-right outside edge of the shelf

assembly.

If you installed an AEP, continue with the

AEP" procedure on page

1-17.

If you did not install an AEP and you plan to install electrical cards, continue with the

Install the Electrical Card Cables on the Backplane" procedure on page

If you did not install an AEP and do not plan to install electrical cards, continue with the

Install the Rear Cover" procedure on page

This procedure connects an external wire-wrap panel to the AEP to provide

the physical alarm contacts for the AEP.

External wire-wrap panel

NTP-A119 Install the Alarm Expansion Panel, page 1-13

As needed

Onsite

None

NTP- A120 Install an External Wire-Wrap Panel to the AEP

"NTP-A120 Install an External Wire-Wrap Panel to the

1-23.

(Figure

1-5).

Cisco ONS 15454 Procedure Guide, Release 8.5.1

as needed. Craft wires (or

"NTP-A9

1-22.

"NTP-A11

1-17