Cisco UCS C240 Manual de instalação - Página 10

Procurar online ou descarregar pdf Manual de instalação para Servidor Cisco UCS C240. Cisco UCS C240 22 páginas. Connected safety and security (css)
Também para Cisco UCS C240: Manual do utilizador (22 páginas)

Imprimir página

Initial Server Setup

Connecting and Powering On the Server (Standalone Mode)

This section describes how to power on the server, assign an IP address, and connect to server

Note

management when using the server in standalone mode. To use the server in UCS integration, specific

cabling and settings are required. See

The server is shipped with these default settings:

•

Use the following procedure to perform initial setup of the server:

Attach a supplied power cord to each power supply in your server, and then attach the power cord to a

Step 1

grounded AC power outlet. See the

Wait for approximately two minutes to let the server boot in standby power during the first bootup.

You can verify power status by looking at the Power Status LED (see

•

Note

Step 2

Connect a USB keyboard and VGA monitor by using the supplied KVM cable connected to the KVM

connector on the front panel (see

Note

Cisco UCS C240 Server Installation and Service Guide

2-10

The NIC mode is Shared LOM EXT.

Shared LOM EXT mode enables the 1-Gb Ethernet ports and the ports on any installed Cisco virtual

interface card (VIC) to access the Cisco Integrated Management Interface (Cisco IMC). If you want

to use the 10/100 dedicated management ports to access the Cisco IMC, you can connect to the

server and change the NIC mode as described in

The NIC redundancy is active-active. All Ethernet ports are utilized simultaneously.

DHCP is enabled.

Internet protocol version 4 (IPv4) is enabled.

Off—There is no AC power present in the server.

Amber—The server is in standby power mode. Power is supplied only to the CIMC and some

motherboard functions.

Green—The server is in main power mode. Power is supplied to all server components.

During bootup, the server beeps once for each USB device that is attached to the server. Even if

there are no external USB devices attached, there is a short beep for each virtual USB device

such as a virtual floppy drive, CD/DVD drive, keyboard, or mouse. A beep is also emitted if a

USB device is hot-plugged or hot-unplugged during BIOS power-on self test (POST), or while

you are accessing the BIOS Setup utility or the EFI shell.

Alternatively, you can use the VGA and USB ports on the rear panel. However, you cannot use

the front panel VGA and the rear panel VGA at the same time. If you are connected to one VGA

connector and you then connect a video device to the other connector, the first VGA connector

is disabled.

Installation for Cisco UCS Integration, page

Step 4

Power Specifications, page A-2

Figure 1-1 on page

1-2).

Chapter 2

Installing the Server

D-1.

of the following procedure.

for power specifications.

Figure 1-1 on page

1-2):

OL-25761-01