Cisco UCS C240 Manual de instalação - Página 11

Procurar online ou descarregar pdf Manual de instalação para Servidor Cisco UCS C240. Cisco UCS C240 22 páginas. Connected safety and security (css)
Também para Cisco UCS C240: Manual do utilizador (22 páginas)

Imprimir página

Chapter 2

Installing the Server

Open the Cisco IMC Configuration Utility:

Step 3

Press the Power button to boot the server. Watch for the prompt to press F8.

During bootup, press F8 when prompted to open the Cisco IMC Configuration Utility. Note the

differences between versions of Cisco IMC firmware:

–

Figure 2-6

Set NIC mode and NIC redundancy:

Step 4

Set the NIC mode to your choice for which ports to use to access the CIMC for server management

(see

Shared LOM EXT (default)—This is shared LOM extended mode. This is the factory-default

•

setting, along with Active-active NIC redundancy and DHCP-enabled. With this mode, the shared

LOM and Cisco Card interfaces are both enabled.

In this mode, DHCP replies are returned to both the shared LOM ports and the Cisco card ports. If

the system determines that the Cisco card connection is not getting its IP address from a Cisco UCS

Manager system because the server is in standalone mode, further DHCP requests from the Cisco

card are disabled. Use the Cisco Card NIC mode if you want to connect to the CIMC through a Cisco

card in standalone mode.

Dedicated—The dedicated management port is used to access the CIMC. You must select a NIC

•

redundancy and IP setting.

Shared LOM—The 1-Gb Ethernet ports are used to access the CIMC. You must select a NIC

•

redundancy and IP setting.

Cisco Card—The ports on an installed Cisco UCS virtual interface card (VIC) are used to access the

•

CIMC. You must select a NIC redundancy and IP setting.

Note

OL-25761-01

In Cisco IMC 2.0(1) and later, there are two windows for this utility that you can switch between

by pressing F1 or F2 (see

dynamic domain name system (DDNS) are supported. You can also define a host name and a

DDNS domain.

In Cisco IMC earlier than release 2.0(1), there is only one window for this utility. Only the IPv4

protocol is supported. DDNS is not supported.

Cisco IMC Configuration Utility Window 1 and Window 2 (Cisco IMC 2.0(1) and Later)

Figure 1-3

for identification of the ports):

The Cisco Card NIC mode is currently supported only with a Cisco UCS VIC that is installed in

PCIe slot 2. See also

Special Considerations for Cisco UCS Virtual Interface Cards, page

Figure 2-6

for sample windows). The IPv4 and IPv6 protocols and

Cisco UCS C240 Server Installation and Service Guide

Initial Server Setup

3-44.

2-11