Cisco 3600 Series Nota de configuração - Página 22

Procurar online ou descarregar pdf Nota de configuração para Porta de entrada Cisco 3600 Series. Cisco 3600 Series 25 páginas. Memory upgrade
Também para Cisco 3600 Series: Visão geral do produto (10 páginas), Instruções de atualização (30 páginas), Manual do Proprietário (17 páginas), Nota de aplicação (41 páginas), Manual de configuração (36 páginas), Manual do utilizador (25 páginas), Apêndice (15 páginas), Manual do utilizador (7 páginas), Manual (5 páginas), Nota de configuração (23 páginas), Nota de configuração (18 páginas)

Cisco 3600 Series Nota de configuração
Replacing Connections to the Router
Figure 17
Replacing Connections to the Router
Follow these steps to make final connections to the router:
Warning
see translated versions of this warning, refer to the Regulatory Compliance and Safety Information
document that accompanied the router.)
Step 1
Step 2
Step 3
Step 4
22 Cisco 3600 Series Memory Upgrade Configuration Note
Replacing the Cisco 3640 Cover
Read the installation instructions before you connect the system to its power source. (To
Replace all network connections.
If you have an AC-powered router, plug the power cord into a 3-terminal, single-phase
power source that provides power within the acceptable range (100 to 240 VAC, 50 to
60 Hz).
If you have a DC-powered router, remove the tape from the circuit breaker switch handle
and reinstate power by moving the handle of the circuit breaker to the ON position.
Turn ON the power switch. The power LED on the front panel of the router should go
ON.)
Check the OK LED on the right side of the front panel to verify that it goes ON after a
few seconds delay when booting. If you have problems, see the next section, "Obtaining
Service and Support."