Cisco 3600 Series Yapılandırma Notu - Sayfa 22

Ağ Geçidi Cisco 3600 Series için çevrimiçi göz atın veya pdf Yapılandırma Notu indirin. Cisco 3600 Series 25 sayfaları. Memory upgrade
Ayrıca Cisco 3600 Series için: Ürüne Genel Bakış (10 sayfalar), Yükseltme Talimatları (30 sayfalar), Kullanıcı El Kitabı (17 sayfalar), Uygulama Notu (41 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (25 sayfalar), Ekler (15 sayfalar), Kullanıcı Kılavuzu (7 sayfalar), Manuel (5 sayfalar), Yapılandırma Notu (23 sayfalar), Yapılandırma Notu (18 sayfalar)

Cisco 3600 Series Yapılandırma Notu
Replacing Connections to the Router
Figure 17
Replacing Connections to the Router
Follow these steps to make final connections to the router:
Warning
see translated versions of this warning, refer to the Regulatory Compliance and Safety Information
document that accompanied the router.)
Step 1
Step 2
Step 3
Step 4
22 Cisco 3600 Series Memory Upgrade Configuration Note
Replacing the Cisco 3640 Cover
Read the installation instructions before you connect the system to its power source. (To
Replace all network connections.
If you have an AC-powered router, plug the power cord into a 3-terminal, single-phase
power source that provides power within the acceptable range (100 to 240 VAC, 50 to
60 Hz).
If you have a DC-powered router, remove the tape from the circuit breaker switch handle
and reinstate power by moving the handle of the circuit breaker to the ON position.
Turn ON the power switch. The power LED on the front panel of the router should go
ON.)
Check the OK LED on the right side of the front panel to verify that it goes ON after a
few seconds delay when booting. If you have problems, see the next section, "Obtaining
Service and Support."