Motorola GP140 Series Manual de serviço básico - Página 24

Procurar online ou descarregar pdf Manual de serviço básico para Rádio portátil Motorola GP140 Series. Motorola GP140 Series 46 páginas. Professional radio, power distribution and controller
Também para Motorola GP140 Series: Manual do utilizador (20 páginas), Informações sobre o serviço (32 páginas), Informações sobre o serviço (30 páginas), Informações sobre o serviço (30 páginas)

3-10

6.6

Control Top Disassembly

To remove the control top assembly, place a screwdriver next to the antenna boss, and pry it

against the control top escutcheon. This will lift the control top escutcheon away from its

double-sided adhesive. Grab the double-sided adhesive near the volume potentiometer, and

lift it away.

Remove the control top seal, emergency button, and transmit light pipe.

7.0

Radio Reassembly Ñ Detailed

7.1

Replace transmit light pipe and control top seal.

Place a new control top escutcheon adhesive against the front cover. Press the control top

escutcheon tightly against the adhesive.

Put the PTT seal in the PTT bezel.

7.2

Place the bezel top tab in the top slot inside the front cover PTT opening. Slightly bow the

bezel so that the bottom tab can fall inside the bottom slot.

Press the PTT assembly against the front cover opening.

NOTE

Look inside the front cover to make sure the T-tab is fully engaged with the front cover. If

necessary, press the T-tab toward the top of the radio until it becomes fully engaged.

7.3

Feed the universal connector tail of the speaker-microphone ßex assembly through the open-

ing in the side wall of the front cover.

Peel-off the adhesive liner on the back of the universal connector tail of the ßex circuit. Attach

the ßex tail to the front cover using the guide pins for correct alignment.

Replace the universal connector escutcheon. Make sure that all the connector openings align

with the gold pads on the ßex circuit.

Align the notch in the speaker at the twelve oÕclock position with the tab on the front cover.

(See Figure 3-8.)

Place the speaker retainer bracket into the hole on the top of the front cover, and bend the

retainer down to Þt underneath the boss below the speaker.

7.4

If you are replacing the display, use a new double-sided adhesive display pad (item number

17 on the exploded view diagram).

Replace the keypad, and the keypad/option board. Make sure the display module ßex tail is

connected correctly to the connector on the keypad/option board.

Insert the Òtop hooksÓ of the keypad retainer into the slots below the speaker (above the dis-

MAINTENANCE