Aries FilterWorks HPL-RO Manual de instalação e serviço - Página 2

Procurar online ou descarregar pdf Manual de instalação e serviço para Sistemas de filtragem de água Aries FilterWorks HPL-RO. Aries FilterWorks HPL-RO 7 páginas. Reverse osmosis system

Imprimir página
Introduction:
Read this entire service guide before beginning installation. The Aries HPL-RO system has been
designed for quick and simple installation and maintenance. By carefully reading this instruction
manual and following the operational guidelines, successful installation and reliable operation
will be insured.
System Description:
The Aries HPL-RO system is a 4-stage filtration system designed to remove more than 93% of
dissolved solids of a potable water supply. The purpose of each stage is described below:
Stage (1) – Sediment Filter: 5.0 micron filter designed to remove suspended particles like silt,
sand, or clay.
Stage (2) – Granular Activated Carbon: 20 x 50 mesh carbon designed to remove chlorine and
organics.
Stage (3) – Membrane Pre Filter: 1.0 micron filter designed to trap carbon fines and other
smaller suspended particles.
Stage (4) – Thin Film Composite Membrane: Polyamide reverse osmosis membrane that uses a
cross flow design to produce two product streams: permeate and concentrate. Permeate is the
purified stream that has >93% of dissolved solids removed. Concentrate is the removed salt
content that is sent to drain.
Conditions for Operation - Thin Film Composite Membrane:
Source Water Supply
System Pressure – 2.1 – 6.9 bar (30-100 psi)
Temperature – 4 - 38 ºC (40 - 100 ºF)
ph Range – 3.0 to 11.0
Maximum Supply TDS level – 2000 mg/L
Turbidity - < 1.0 net turbidity (NTU)
Chemical Parameter
Hardness - < 350 mg/L (<20 gpg)
Iron (Fe) - < 0.1 mg/L
Manganese - < 0.05 mg/L
Hydrogen Sulfide (H
) – 0.00 mg/L
Chlorine (Cl
2
CAUTION: DO NOT USE THIS SYSTEM WHERE THE WATER IS MICROBIOLOGICALLY UNSAFE OR
OF UNKNOWN QUALITY. THIS SYSTEM IS FOR USE ON POTABLE WATER ONLY. SOURCE WATER
EXCEEDING CHEMICAL PARAMETERS REQUIRES PRETREATMENT.
M-0221201113
Revision 4
S) – 0.00 mg/L
2
Page 2 of 7