Dimplex ELECTRALOG CS1205 Manual de serviço - Página 13
Procurar online ou descarregar pdf Manual de serviço para Fogão Dimplex ELECTRALOG CS1205. Dimplex ELECTRALOG CS1205 16 páginas. Electric stove
Também para Dimplex ELECTRALOG CS1205: Manual do Proprietário (12 páginas), Manual do Proprietário (11 páginas), Manual do Proprietário (11 páginas)
Imprimir página
- 1. Table of Contents
- 2. Operation
- 3. Replacement Parts
- 4. Wiring Diagram
- 5. To Replace Light Bulbs
- 6. To Replace Lampholders
- 7. To Replace On/Off and Heater Switches
- 8. To Replace Heater Assembly
- 9. To Replace Terminal Block
- 10. To Replace Flame Motor/Flame Rod
- 11. To Replace the Power Cord
- 12. Troubleshooting Guide
CS1205
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE THE POWER CORD
1. Turn the stove over and place it top down.
2. Remove the bottom heater assembly cover being careful not to damage any of the
wiring.
3. Remove the 4 heater retaining screws from the bottom of the heater assembly cover
and move the heater to gain access to the switch connections.
4. Located and disconnect the power cord wiring connections from the heater and Main
on/off switch noting their original locations.
5. With needle nose pliers grasp the power cord strain relief grommet from inside the
rear panel and push while twisting to remove.
6. Pull the power cord out through the hole in the rear cover.
7. Install the new cord set through the hole in the rear cover by placing the strain relief
over the cord, hold the strain relief with pliers and slide into mounting hole.
8. Connect all of the wiring connections in their original locations.
9. Reassemble in the reverse order as above.
12