Dimplex ELECTRALOG CS1205 Посібник з експлуатації - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Піч Dimplex ELECTRALOG CS1205. Dimplex ELECTRALOG CS1205 16 сторінок. Electric stove
Також для Dimplex ELECTRALOG CS1205: Посібник користувача (12 сторінок), Посібник користувача (11 сторінок), Посібник користувача (11 сторінок)
Друкувати сторінку
- 1. Table of Contents
- 2. Operation
- 3. Replacement Parts
- 4. Wiring Diagram
- 5. To Replace Light Bulbs
- 6. To Replace Lampholders
- 7. To Replace On/Off and Heater Switches
- 8. To Replace Heater Assembly
- 9. To Replace Terminal Block
- 10. To Replace Flame Motor/Flame Rod
- 11. To Replace the Power Cord
- 12. Troubleshooting Guide
CS1205
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE THE POWER CORD
1. Turn the stove over and place it top down.
2. Remove the bottom heater assembly cover being careful not to damage any of the
wiring.
3. Remove the 4 heater retaining screws from the bottom of the heater assembly cover
and move the heater to gain access to the switch connections.
4. Located and disconnect the power cord wiring connections from the heater and Main
on/off switch noting their original locations.
5. With needle nose pliers grasp the power cord strain relief grommet from inside the
rear panel and push while twisting to remove.
6. Pull the power cord out through the hole in the rear cover.
7. Install the new cord set through the hole in the rear cover by placing the strain relief
over the cord, hold the strain relief with pliers and slide into mounting hole.
8. Connect all of the wiring connections in their original locations.
9. Reassemble in the reverse order as above.
12