Pioneer AVH-P5750DVD Manual de instalação - Página 13
Procurar online ou descarregar pdf Manual de instalação para Recetor para automóvel Pioneer AVH-P5750DVD. Pioneer AVH-P5750DVD 44 páginas. Avh-p5750dvd
Também para Pioneer AVH-P5750DVD: Manual de instalação (8 páginas)
Imprimir página
A Title (English)
Installation
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver's way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• Do not install the display where it may (i) obstruct
the driver's vision, (ii) impair the performance of
any of the vehicle's operating systems or safety
features, including air bags, hazard lamp buttons
or (iii) impair the driver's ability to safely operate
the vehicle.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
— for instance, near a heater outlet.
• If installation angle exceeds 30° from horizontal,
the unit might not give its optimum performance.
(Fig. 12)
• The cords must not cover up the area shown in the
figure below. This is necessary to allow the
amplifires to radiate freely. (Fig. 13)
Evite cerrar este área.
Installing the remote control unit
When not using the remote control
unit, secure it with velcro tape to pre-
vent it from moving.
• Thoroughly wipe off the surface
before affixing the velcro tape.
30°
Fig. 12
Fig. 13
Remote control unit
Velcro tape (small)
(hard)
Velcro tape (small)
(soft)
Fig.14
12