Pioneer AVH-P5750DVD 설치 매뉴얼 - 페이지 13

{카테고리_이름} Pioneer AVH-P5750DVD에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AVH-P5750DVD 44 페이지. Avh-p5750dvd
Pioneer AVH-P5750DVD에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지)

페이지 인쇄

A Title (English)

Installation

Note:

• Before finally installing the unit, connect the

wiring temporarily, making sure it is all connect-

ed up properly, and the unit and the system work

properly.

• Use only the parts included with the unit to ensure

proper installation. The use of unauthorized parts

can cause malfunctions.

• Consult with your nearest dealer if installation

requires the drilling of holes or other modifica-

tions of the vehicle.

• Install the unit where it does not get in the dri-

ver's way and cannot injure the passenger if there

is a sudden stop, like an emergency stop.

• Do not install the display where it may (i) obstruct

the driver's vision, (ii) impair the performance of

any of the vehicle's operating systems or safety

features, including air bags, hazard lamp buttons

or (iii) impair the driver's ability to safely operate

the vehicle.

• The semiconductor laser will be damaged if it

overheats, so don't install the unit anywhere hot

— for instance, near a heater outlet.

• If installation angle exceeds 30° from horizontal,

the unit might not give its optimum performance.

(Fig. 12)

• The cords must not cover up the area shown in the

figure below. This is necessary to allow the

amplifires to radiate freely. (Fig. 13)

Evite cerrar este área.

Installing the remote control unit

When not using the remote control

unit, secure it with velcro tape to pre-

vent it from moving.

• Thoroughly wipe off the surface

before affixing the velcro tape.

30°

Fig. 12

Fig. 13

Remote control unit

Velcro tape (small)

(hard)

Velcro tape (small)

(soft)

Fig.14