Pioneer VSX-D704S Manual de Instruções - Página 16

Procurar online ou descarregar pdf Manual de Instruções para Recetor estéreo Pioneer VSX-D704S. Pioneer VSX-D704S 40 páginas. Audio/video stereo receiver

Imprimir página

FRONT PANEL FACILITIES

_7_DIRECT

button*

Press 1his to listen to source sound without passing the audio

signal through sound quality and balance adjusting circuitry.

The surround mode, super bass, and rear and center speakers

are automatically

switched off.

MULTI-JOG

Use during tuner operation to select frequencies and station

numbers. During GUIoperation, use to move the on-screen cursor.

_ GUI ENTER button

(GUI operation)

Press to execute an operation selected with the MULTI-JOG

_0_ MUTING

button

Press to temporarily cut off the sound volume. When pressed

again, the sound will return to its previous level.

_]) GUI MODE button

Switches GUI MODE on and off.

_ MASTER

VOLUME

control

Use it to simultaneously

adjust the sound volume from the

front, center, and rear speakers.

_3_SLEEP button

Activates

the SLEEP timer.

The length changes

in the

following manner each time the button is pressed:

90 -_*

60 -_

30 _

off

Unit: minutes

H_PHONES

jack

Connect the plug on your headphones to this jack. Set SPEAKERS

A and B switches to OFF if you want to cut the sound from the

speakers and listen to it only through the headphones.

VIDEO INPUT jacks

VIDEO components

such as a VCR or -IV camera, etc. can be

connected.

_f6_ SUPER

BASS

button*

Press this button when you want to boost the bass.

@ Display

section

See page 17.

@ TUNING

MODE buttons

FM/AM button:

Usethisto switch between FM andAM frequencybandreception.

MPX MODE

button:

Use to select the auto stereo mode or monaural mode when

listening to FM broadcasts. The monaural mode has been

selected when the MONO indicator in the display section is lit.

Auto stereo mode

Normally, leave in this mode for reception. When a stereo FM

broadcast is received, it will be automatically reproduced in stereo.

Monaural mode

When receiving distant stations or stations with weak broadcast

signals, the input signal may be weak, thus resulting in increased

noise during FM stereo broadcasts. Inthis event, setting the receiver

to the monaural mode will reduce the noise. In this case, however,

FM stereo broadcasts will be reproduced in monaural sound.

NOTE:

This button

has no effect

on reception

of AM broadcasts.

MEMORY

button:

Press this button to switch to the frequency preset mode.

(When GUI is ON, it does not operate.)

ENTER

button:

Press this button when you are in the frequency preset mode, and

the displayed frequency is memorized in the selected station.

(Station indications stop flashing and stay lit.)

(When GUI is ON, it does not operate.)

SELECT

button:

Press this button to switch to the station mode. Then you

can turn the multi-jog to select a station.

(When GUI is ON, it does not operate.)

(_ DOLBY PRO-LOGIC

button*

Switches DOLBY PRO-LOGIC SURROUND on and off.

(_ DSP MODE

button*

Each time you press it, the mode and the display indications

change as follows.

--*JAZZ

-_,-DANCE

---*

SIMULATED SURROUND 7

off -,--- PRO-LOGIC THEATER _

HALL ,,

@ DOLBY 3CH LOGIC button*

Select this setting when stereo-source regeneration and rear

speakers are not connected and you wish to use the front L,

front R, and center speakers to enjoy audio/visual material

bearing the DrI[DOLRV SU..DU.OJ mark.

@ BASS

control

Use to adjust the low-frequency level. Turn clockwise to boost

bass, and counterclockwise

to attenuate bass.

@ TREBLE control

Use to adjust the high-frequency

level. Turn clockwise

boost treble, and counterclockwise

to attenuate treble.

BALANCE

control

Use to adjust the sound volume balance between left and right

speakers.

L: Decreases the sound on the right side.

R: Decreases the sound on the left side.

Usually, left and right volume levels should be the same.

*Setting

is memorized

separately for each input selector

button.