Pioneer GM-A6704 Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Pioneer GM-A6704. Pioneer GM-A6704 19 páginas. Bridgeable four-channel power amplifier
Também para Pioneer GM-A6704: Manual do Proprietário (33 páginas)

Imprimir página

(Connecting the units

)

Please see the following sect1on for speaker

connection

inst~-uct1ons.

Refer to Connections

when using the speaker input wire.

9 Speake~-

output terminals

Please see the following section for speaker

connection instructions. Refer to Connecting

the speakers.

System remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem

~-emote

control terminal of the car

ste~-eo.

The female term 1 nal can be connected to the

auto-antenna relay control terminal. If the car

stereo lacks a system remote control terminal,

connect the male terminal to the power term-

inal v1a the 1gnition switch.

Fuse 25 Ax 2 (GM-A6704)

30 Ax 1 (GM-

A4704)

Fuse (30 A) x 2

Grommet

Rear side

Front side

Note

INPUT SELECT (input select) switch must be set.

Fot- detai Is. see Setting the un/t. ~

Before connecting the

amplifier

wARNING

• Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

•

Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

cAUTION

•

Never shorten any wires, the protection circuit

may malfunction.

•

Never wire the speaker negative cable directly

to ground.

•

Never band together multiple speaker's nega-

tive cables.

•

If the system remote control wire of the arrlpli-

fier is connected to the power term mal via the

1gnition sw1tch (12 V DC). the amplif1er w1ll re-

main on w1th the ignition

whethe~-

the car

stereo is on or off. which may exhaust battery

if the eng me is at rest or 1dling.

•

Install and route the separately sold battery

wire as far as possible hom the speaket- wit-es.

Install and

~-oute

the separately sold battery

wire. ground wire, speaker wires and the am-

plifiet- as far away as possible from the anten-

na, antenna cable and tuner.~

About bridged mode

Diagram A - Proper

LEE)

Pioneer

Amplifier

Bndged Mode

Diagram B- Improper

L<±>

Pioneer

Amp!lfier

2 Q Bndged Mode

•

Do not install or use this amplifier by wiring

speakers rated at 4

(or lower) in parallel to

achieve a 2

(or lower) bridged mode (Dia-

gram B).

Am pi ifier damage, smoke, and overheating

could result from improper bridging. The am-

plifier surface could also become hot to the

touch and minor burns could result.

To properly install or use a bridged mode and

achieve a 4[2 load, wire two

speakers in

parallel with Left® and Right

(Diagram A)

or use a single 4D speaker.

In addition, refer to the speaker i nstruct1on

manual for information on the correct con nec-

tion procedure.

•

For any further enquiries, contact your local

authorized Pioneer dealer or customer

service.~