Aeotec Door / Window Sensor 7 Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Acessórios Aeotec Door / Window Sensor 7. Aeotec Door / Window Sensor 7 10 páginas.
Também para Aeotec Door / Window Sensor 7: Manual do utilizador (9 páginas), Manual de início rápido (11 páginas), Manual do utilizador (9 páginas)

Imprimir página

Aeotec Door / Window Sensor 7 Manual do utilizador

31/07/2019

#3: Digital Input

#4: Ground

Digital + Ground is used to connect an external dry contact mechanism to control scenes.

Push button

Water sensor probes

External magnet detection

etc.

Note: Please note that the contact Digital Input (#3) and Ground (#4) is a normally open (NO) contact. Closing the

contact sends out a command (Open or Close). You must use a NO dry contact device with these terminals.

Door / Window Sensor 7 as Dry Contact Sensor.

Using conﬁguration commands the source of "open" and "close" events can be chosen between the internal magnet

detector or external dry contact connected on terminal #3 and #4.

You can ﬁnd direct information in this article here:

https://aeotec.freshdesk.com/support/solutions/articles/6000223859

(https://aeotec.freshdesk.com/support/solutions/articles/6000223859)

Scene Controller.

When activated by configuration parameter #13 the device can perform as a scene controller. The external dry contact

will then act as a scene controller with a total of 7 scenes that can be activated:

1. Contact Pressed 1 time

2. Contact Pressed 2 time

3. Contact Pressed 3 time

4. Contact Pressed 4 time

5. Contact Pressed 5 time

6. Contact held down

7. Contact released

You can find out more information on how to use Door / Window Sensor 7 in this article here:

https://aeotec.freshdesk.com/support/solutions/articles/6000223885

(https://aeotec.freshdesk.com/support/solutions/articles/6000223885)

Communication test.

This utilizes the Power Level command class to determine the health between the Door / Window Sensor 7 and your

Z-Wave gateway. This will tell you if the Door / Window Sensor 7 has a healthy connection to your system and is a

great method of debugging connectivity issues.

1. Set Parameter #4 to value #1

2. Double click the Tamper Switch.

3. Result:

Blinks once - success

Blinks 5x times - failure

https://aeotec.freshdesk.com/support/solutions/articles/6000218764-door-windows-sensor-7-user-guide

Door / Window 7 user guide : Aeotec Group

6/10