Ariston 7HPC 604 XHA Manual de Instruções - Página 4

Procurar online ou descarregar pdf Manual de Instruções para Hob Ariston 7HPC 604 XHA. Ariston 7HPC 604 XHA 16 páginas.

Imprimir página

Ariston 7HPC 604 XHA Manual de Instruções

an oven without a forced ventilation cooling system,

adequate ventilation must be provided inside the

cabinet by means of air holes through which air can

pass (see figure).

Electrical connection

The electric hobs are supplied without power supply

cable since the cable must be sized according to

the type of electrical connection used (see attached

connection diagram). Follow these steps to connect

the cable:

• Open the terminal box by removing the screws "V"

and opening the cover (see figure).

• Connect the wires as shown in the diagram.

• Fix the cable using the cable clamp "F", replace the

cover and fasten it using the screws "V" (see figure).

H05RR-F 5x1.5 CEI-UNEL 35363

H05RR-F 4x1.5 CEI-UNEL 35363

Where

a hob is

H05RR-F 3x2.5 CEI-UNEL 35363

installed

above

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate.

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum

contact opening of 3 mm installed between the

appliance and the mains. The circuit-breaker must be

suitable for the charge indicated and must comply with

current electrical regulations (the earthing wire must

not be interrupted by the circuit-breaker). The supply

cable must not come into contact with surfaces with

temperatures higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant with

safety regulations.

Before connecting to the power supply, make sure that:

• The appliance is earthed and the plug is compliant

• The socket can withstand the maximum power of the

• The voltage is in the range between the values

• The socket is compatible with the plug of the

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

! The manufacturer declines any liability should these

safety measures not be observed.

! If the appliance is to be installed above a built-in

electric oven, the electrical connection of the hob

and the oven must be carried out separately, both for

electrical safety purposes and to make extracting the

oven easier.

380-400V 3N~

380-400V 2N~

220-230V 1N~

with the law.

appliance, which is indicated on the data plate.

indicated on the data plate.

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it. Do

not use extension cords or multiple sockets.

S N