Ariston 7HPC 604 XHA Інструкція з експлуатації Посібник з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Варильна поверхня Ariston 7HPC 604 XHA. Ariston 7HPC 604 XHA 16 сторінок.
Друкувати сторінку
GB
an oven without a forced ventilation cooling system,
adequate ventilation must be provided inside the
cabinet by means of air holes through which air can
pass (see figure).
Electrical connection
The electric hobs are supplied without power supply
cable since the cable must be sized according to
the type of electrical connection used (see attached
connection diagram). Follow these steps to connect
the cable:
• Open the terminal box by removing the screws "V"
and opening the cover (see figure).
• Connect the wires as shown in the diagram.
• Fix the cable using the cable clamp "F", replace the
cover and fasten it using the screws "V" (see figure).
V
4
H05RR-F 5x1.5 CEI-UNEL 35363
H05RR-F 4x1.5 CEI-UNEL 35363
Where
a hob is
H05RR-F 3x2.5 CEI-UNEL 35363
installed
above
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load
indicated on the data plate.
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum
contact opening of 3 mm installed between the
appliance and the mains. The circuit-breaker must be
suitable for the charge indicated and must comply with
current electrical regulations (the earthing wire must
not be interrupted by the circuit-breaker). The supply
cable must not come into contact with surfaces with
temperatures higher than 50°C.
! The installer must ensure that the correct electrical
connection has been made and that it is compliant with
safety regulations.
Before connecting to the power supply, make sure that:
• The appliance is earthed and the plug is compliant
• The socket can withstand the maximum power of the
• The voltage is in the range between the values
• The socket is compatible with the plug of the
1
2
3
4
5
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only (see Assistance).
! The manufacturer declines any liability should these
safety measures not be observed.
! If the appliance is to be installed above a built-in
electric oven, the electrical connection of the hob
and the oven must be carried out separately, both for
electrical safety purposes and to make extracting the
oven easier.
380-400V 3N~
R
380-400V 2N~
220-230V 1N~
with the law.
appliance, which is indicated on the data plate.
indicated on the data plate.
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
1
2
3
4
5
T
S
N
1
2
3
4
5
R
S N
4
3
5
1
2
N
R