Whirlpool Cabrio,- WED7300X Manual de utilização e cuidados - Página 11

Imprimir página

Whirlpool Cabrio,- WED7300X Manual de utilização e cuidados

Select cycle options

Select any other cycle options you may wish to add, if not

previously set. Some cycles will automatically add certain

options such as Deep Clean or Extra Rinse. These may be

turned off, if desired.

NOTE: Not all options are available with all cycles.

10.

Press and hold START/PAUSE

to begin wash cycle

Press the START/PAUSE button to start the wash cycle.

When the cycle has finished, the DONE indicator will light and the

end of cycle signal will sound (if set).

Promptly remove garments when cycle is done to prevent odor,

reduce wrinkling, and rusting of metal hooks, zippers, and snaps.

NOTE:

If you need to open the lid to add 1 or 2 missed garments, you

may do so while the Add a Garment indicator is lit.

Press START/PAUSE; the lid will unlock once the washer

movement has stopped. This may take several minutes if the

load was spinning at high speed. Then close lid and press

START/PAUSE again to restart the cycle.

If lid is left open for more than 10 minutes the water will

pump out.

WASHER MAINTENANCE

WATER INLET HOSES

Replace inlet hoses after 5 years of use to reduce the risk

of hose failure. Periodically inspect and replace inlet hoses

if bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, mark the date of

replacement on the label with a permanent marker.

CLEANING YOUR WASHER

Keep your washer as clean and fresh as your clothes.

To keep washer interior odor-free, follow this recommended

monthly cleaning procedure:

1. Make sure the washer is empty.

2. Using recommended AFFRESH

add one tablet to washer drum

If using liquid chlorine bleach, add 1 cup (250 mL) to

liquid chlorine bleach dispenser.

IMPORTANT: Do not add detergent to CLEAN

WASHER with AFFRESH

recommended amount of bleach to avoid damaging

product over time.

3. Close washer lid.

4. Press POWER.

5. Select CLEAN WASHER with AFFRESH

6. Press START/PAUSE. Water will pour into washer

for a moment and pause, lid will lock, then cycle

will continue.

NOTE: For best results, do not interrupt cycle. If cycle must

be interrupted, press START/PAUSE twice and run a RINSE

AND SPIN cycle to ensure cleaner or bleach have been

rinsed from washer.

To clean exterior:

1. Use a soft, damp cloth or sponge to wipe up any spills.

2. Use all-purpose surface cleaner, if needed.

IMPORTANT: To avoid damaging the washer's finish,

do not use abrasive products.

washer cleaner,

™

cycle. Do not use more than

cycle.