Whirlpool UXT4230AD Manual de instruções de instalação - Página 10

Procurar online ou descarregar pdf Manual de instruções de instalação para Campânula de ventilação Whirlpool UXT4230AD. Whirlpool UXT4230AD 34 páginas. 30" (76.2 cm) and 36" (91.4 cm) range hood
Também para Whirlpool UXT4230AD: Instruções de instalação e manual de utilização e cuidados (28 páginas), Instruções de instalação e manual de utilização e cuidados (28 páginas), Instruções de instalação e manual de utilização e cuidados (28 páginas)

5. Remove vent knockouts depending on your installation

requirements.

A. Round vent knockout

B. Top rectangular vent knockout

C. Rear rectangular vent knockout

Round vent system installations - Remove top rectangular

and round vent knockouts.

Rectangular vent system installations - For roof

installations, remove the top rectangular vent knockout. For

wall installations, remove the rear rectangular vent knockout.

Non-vent (recirculating) installations - Do not remove any

knockouts.

6. Install 7" (17.8 cm) round vent mounting plate or 3¼" x 10"

(8.3 x 25.4 cm) vent damper, depending on your vent system

installation. Attach to range hood 3.5 x 9.5 mm screws

provided.

NOTE: The 7" (17.8 cm) round vent mounting plate is not

supplied. An optional 7" (17.8 cm) round damper is also

available as an accessory. For information on ordering, see

the "Accessories" section.

A. 7" (17.8 cm) Round damper (see "Accessories" section)

B. 3.5 x 9.5 mm screws

C. 7" (17.8 cm) round vent mounting plate. For information

on ordering, see the "Accessories" section.

D. Round vent knockout

E. Rectangular vent knockout

NOTE: The 7" (17.8 cm) round vent mounting plate and

3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular vent damper can be

installed up to 1" (2.5 cm) on either side of the hood

center to accommodate off center ductwork.

A. Vertical damper

B. 3.5 x 9.5 mm screws

C. Vent knockouts

D. Horizontal damper

If a vent damper is installed with a wall cap with damper,

check that they do not interfere with each other. Remove

the vent connector damper flap if they interfere.

Non-vented (recirculating) installations - No vent

attachments. Removal of the recirculation cover plate is

required. Remove the two screws from the recirculation

cover plate and remove.

A. Recirculation cover plate

B. Screws