Alcolizer Easy Check Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Equipamento de teste Alcolizer Easy Check. Alcolizer Easy Check 2 páginas.

Imprimir página

Getting the most out of your Easy Check

• It is recommended to not consume

alcohol, eat, use mouthwash or breath

spray for 15 minutes prior to testing.

• Breath Alcohol Concentration (BAC)

can rise for up to two hours after

last drink. Re-test if in doubt.

• It may take 10 hours or more for

a high BAC level to return to zero.

Further testing later in the day or

the next morning is recommended.

• Calibration is required after six

months. Easy Check will display

'RECAL'. You cannot use the

breathalyser until it is calibrated.

• Do not store unit in places where

moisture or extreme temperature

conditions can occur.

Power Usage/ Batteries

Easy Check is powered by x2 Alkaline

batteries (AAA). Do not replace batteries

- this is done during calibration. Removal

of batteries will incur loss of calibration

and warranty. Note: When not in use,

the back light will turn off and the device

will go into low power standby mode.

Designed, developed and manufactured in Australia by

Alcolizer Technology – the largest supplier of alcohol

detection equipment to Australian law enforcement.

Steps to conduct an Easy Check test:

1. Fit a mouthpiece onto the inlet located

on the (front) left side of the device.

2. Ensure the top-left of the screen

displays 'READY'– you can then press

the button to conduct a test.

3. Easy Check will display an animation

whilst it conducts a quick self-check.

4. When the display shows 'blo', take a

deep breath, and blow steadily into the

mouthpiece. Short beeps will sound

while blowing. Continue to blow until a

click and short musical tone is heard.

5. After a few seconds, your result will be

displayed – Example: '.030g/100ml'.

Note: If you do not blow within 15

seconds, or hard or long enough

a musical tone will sound and the

message, 'TRY AGAIN' will be displayed.

Repeat step 2 onwards to try again.

Recovery period is usually less than one

minute but recovery may take longer after a

high BAC reading.

Easy Check will be ready for a new test

when its recovery period is complete and

the 'READY' message is displayed.

Drive

safe.

Drive

confident.

1300 789 908

www.easycheck.com.au

Excessive Readings

The display will flash if your reading

exceeds the device limit of .300g/100ml.

Other Functions

Press and hold the button to display the

following information:

• The last reading

• The number of tests remaining

till calibration

• The number of days before

calibration is due

The information will continue to be

displayed, in sequence for three seconds

each, for as long as the button is

pressed.

Display Illumination

The display light automatically turns off

after a few seconds.

If the result is displaying but 'READY' is

not yet displayed, turn the display light

on again by briefly pressing the button.

Note: When the Easy Check is in low

power standby mode (not backlit), it

will display 'READY' at the top-left of the

screen and also the last BAC test result.