eControls RT2 Manual do proprietário e do instalador - Página 11

Procurar online ou descarregar pdf Manual do proprietário e do instalador para Unidade de controlo eControls RT2. eControls RT2 12 páginas. Wireless whf control
Também para eControls RT2: Manual do utilizador e do instalador (8 páginas)

Imprimir página

Power the WHF and Test Installation.

Make sure the following have been completed

before powering WHF.

FC3J is wired and installed in electrical box on WHF. Ensure wiring is correct for fan type and speed.

FC3J is connected to RM2 radio module using the supplied plug & play cable.

Optional outdoor temperature sensor and/or optional damper control is installed.

Batteries are installed in the RT2 remote thermostat and the RT2 display is on.

The number of fan speeds has been set using the installer options if different than the default.

Apply Power to the WHF.

The RM2 led blinks amber while trying to link to the RT2.

Once the link is established, the led will be solid green

and Linked will be displayed on the RT2 thermostat.

Loss of Communication

In case of a loss of communication, the RM2 radio

module has a built-in safety feature and will automatically

turn the WHF off if the RT2 has not communicated after

15 minutes. So if the RT2 is dropped or the batteries are

removed, the fan will not continuously operate and

eliminates the need to go up into the attic to remove

power to the fan.

INSTALLATION

Test the Installation

From the factory, the RT2 thermostat is in Temperature

Control mode and the WHF (Econo Cooling) is OFF.

Activate the WHF by pressing the Econo Cooling key

and turning the WHF ON. Lower the Set To temperature

to several degrees lower than the Indoor Temperature. If

an optional outdoor temperature sensor is installed, you

may have to temporarily adjust the limit to activate the

WHF. See Page 3. If the outdoor temperature is above

99 degrees, you will have to temporarily disconnect the

sensor wires at the RM2 to continue testing in

Temperature Control. Or, you can switch to Timer

Control. See Page 2, Option 1. Confirm that the WHF

activated.

Using the RT2, check the fan speeds to ensure wiring is

correct.

Turn the WHF off by pressing the Econo Cooling key to

display OFF. Confirm that the WHF turned off.

Helpful Tips

Replacement Units

The RT2 and RM2 in this kit are uniquely addressed and

only work with each other. If you need a replacement

RT2 remote or RM2 radio module, please contact us at

949-916-6701.