eControls RT2 Посібник для власників будинків та інсталяторів - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник для власників будинків та інсталяторів для Блок управління eControls RT2. eControls RT2 12 сторінок. Wireless whf control
Також для eControls RT2: Посібник користувача та інсталятора (8 сторінок)

Друкувати сторінку
5)
Power the WHF and Test Installation.
Make sure the following have been completed
before powering WHF.
FC3J is wired and installed in electrical box on WHF. Ensure wiring is correct for fan type and speed.
FC3J is connected to RM2 radio module using the supplied plug & play cable.
Optional outdoor temperature sensor and/or optional damper control is installed.
Batteries are installed in the RT2 remote thermostat and the RT2 display is on.
The number of fan speeds has been set using the installer options if different than the default.
Apply Power to the WHF.
The RM2 led blinks amber while trying to link to the RT2.
Once the link is established, the led will be solid green
and Linked will be displayed on the RT2 thermostat.

Loss of Communication

In case of a loss of communication, the RM2 radio
module has a built-in safety feature and will automatically
turn the WHF off if the RT2 has not communicated after
15 minutes. So if the RT2 is dropped or the batteries are
removed, the fan will not continuously operate and
eliminates the need to go up into the attic to remove
power to the fan.
INSTALLATION

Test the Installation

From the factory, the RT2 thermostat is in Temperature
Control mode and the WHF (Econo Cooling) is OFF.
Activate the WHF by pressing the Econo Cooling key
and turning the WHF ON. Lower the Set To temperature
to several degrees lower than the Indoor Temperature. If
an optional outdoor temperature sensor is installed, you
may have to temporarily adjust the limit to activate the
WHF. See Page 3. If the outdoor temperature is above
99 degrees, you will have to temporarily disconnect the
sensor wires at the RM2 to continue testing in
Temperature Control. Or, you can switch to Timer
Control. See Page 2, Option 1. Confirm that the WHF
activated.
Using the RT2, check the fan speeds to ensure wiring is
correct.
Turn the WHF off by pressing the Econo Cooling key to
display OFF. Confirm that the WHF turned off.
Helpful Tips
Replacement Units
The RT2 and RM2 in this kit are uniquely addressed and
only work with each other. If you need a replacement
RT2 remote or RM2 radio module, please contact us at
949-916-6701.
11